Installation
Mounting the Conext ComBox
Wall Mount
To mount the Conext ComBox on a wall:
1.Choose the location for mounting the device. Mounting hardware for plywood wall material is supplied.
2.Using the template in the Conext ComBox Quick Start Guide, mark the mounting holes on the wall with a pencil. The holes must be at the same height and 4 7/16 inches (112 mm) apart.
3.Insert the mounting screws supplied in the marked locations on the wall, leaving a space of about ¼ inch (6 mm) between the wall and screw head.
.
¼ inch 
(6 mm)
4.Place the Conext ComBox on the mounting screws, and confirm a snug fit before going to the next step.
5.Connect the wiring and cables. Go to “Wiring the Conext ComBox to an Ethernet Network” on page
