Xantrex Technology Freedom SW Series manual Notice, Equipment Damage, Configuration

Configuration

To connect the Conext ComBox to an existing Xanbus network:

The assumption at this point is that there is an existing Xanbus network and all Xanbus-enabled devices in that network have been previously interconnected with each other.

1.Put the Freedom SW inverter/chargers and Xanbus AGS into standby mode before connecting the Conext ComBox to avoid triggering any unintentional time-based events.

You can put the inverter/chargers out of standby mode later when you have completed configuration of the Conext ComBox.

2.Using the sample illustration below, connect the Conext ComBox to the Xanbus network.

NOTICE

EQUIPMENT DAMAGE

Do not connect a Xanbus RJ-45 cable plug into the 10/100 Ethernet port of the

Conext ComBox.

Failure to follow these instructions can damage equipment or affect network performance.

SCPAGS

SCP

Freedom SW

		Low Battery Battery Type	Search	Battery Bank
		Cutoff	Mode	Capacity (Ah)
Fault	kW Inverting
Batt	A Charging
%
		FREEDOM SW
				2000

Network	Connect to Xanbus ports only
Terminator
Conext ComBox		Freedom SW
				Low Battery Battery Type Search Battery Bank
				CutoffMode Capacity (Ah)
	Fault		kW Inverting
	Batt		A Charging
	%
				FREEDOM SW	2000

Network

Terminator

Be sure to terminate the Xanbus network with Xanbus network terminators at both ends.

3–12 975-0704-01-01 Revision A