Appendix A: Specifications
| Prosine 2.5 | Prosine 3.0 |
INVERTER | ||
Continuous output power / | 2500W / 21A RMS | 3000W / 25A RMS |
current |
|
|
Surge rating (5 seconds) | 4000W | 4000W |
Peak output current | 50A | 50A |
Peak inverter efficiency | 88% | 88% |
No load current draw, in load | <3W | <3W |
sense mode |
|
|
Idle circuit adj. load sensing | OFF, 10W, 25W, 50W [dip | OFF, 10W, 25W, 50W [dip |
| switches] | switches] |
No load current draw, inverter | 60W | 60W |
idle |
|
|
Output frequency | 60Hz ± 0.05% (crystal con- | 60Hz ± 0.05% (crystal con- |
| trolled) | trolled) |
Output waveform | Sine wave <5%THD | Sine wave <5%THD |
Input voltage range | ||
Output voltage (at no load) | 120Vac RMS ± 3% | 120Vac RMS ± 3% |
Output voltage (over full load | 120Vac RMS | 120Vac RMS |
& battery voltage range) |
|
|
Low Battery
High Battery Cut out
Protection
CHARGERBattery capacity selections
Charge Rate 12V (24V) Charger Power Factor Rating Charger Efficiency
Charge banks Charge control Temperature compensation Electrolyte compensation Input voltage range
AC service setting [max. current draw]
Transfer Relay rating
10Vdc, 10.5Vdc warning (20Vdc, 21Vdc warning)
16Vdc (32Vdc)
Automatic overload, short cir- cuit, overtemperature Reverse polarity (fuse)
50, 75, 100, 150, 200, 300, 400, 500, 600, 700, 800, 1000, 1200, 1400, 1700, >2000
100A (50A)
.99
> 80%
1 high current
3 settings or optional sensor flooded/gel
10 [8], 15 [12], 20 [16] , 30 [24] amps
30A
10Vdc, 10.5Vdc warning (20Vdc, 21Vdc warning)
16Vdc (32Vdc)
Automatic overload, short cir- cuit, overtemperature Reverse polarity (fuse)
50, 75, 100, 150, 200, 300, 400, 500, 600, 700, 800, 1000, 1200, 1400, 1700, >2000
120A (60A)
.99
> 80%
1 high current
3 settings or optional sensor flooded/gel
10 [8], 15 [12], 20 [16] , 30 [24] amps
30A
Prosine 2.5/3.0 Installation & Operation Guide | 79 |