Xantrex AC to DC Converter
Connecting the Panel to the XADC DC Side
When following the procedure, see Table 2 on page 24 for wire lengths and
Table 1 on page 24 for torque values.
To connect the panel to the XADC DC side:
1.Remove the DC wiring compartment panel on the XADC (see Figure 8).
2.Loosen the positive and negative screws on the DC connection lugs (see Figure 15).
3.Route the large positive (+) red cable and negative
4.Make the DC ground connections to the ground lug on the right hand side or the top of the XADC, see Figure 10.
5.Slide the negative
6.Slide the positive (+) red cable into the XADC positive DC connection lug and tighten the DC positive screw.
DC positive and negative cable
DC wiring compartment hole
Negative DC connection lug screw
Positive DC connection lug screw
Figure 15 Connecting Panel to XADC DC Side
20 |
