Xerox 4510 manual Manually Setting the Printer’s IP Address

Configuring the Network Address

Manually Setting the Printer’s IP Address

Note: Verify that your computer has a properly configured IP address for your network. Contact your network administrator for more information.

If you are on a network without a DHCP server, or in an environment where the network administrator assigns printer IP addresses, you can use this method to manually set the IP address. Manually setting the IP address overrides DHCP and AutoIP. Alternatively, if you are in a small office with a single PC and use a dialup modem connection, you can manually set the IP address.

Information Required for Manual IP Addressing

Information	Comments
Internet Protocol (IP) address of the printer	Format is xxx.xxx.xxx.xxx, where xxx represents
	a decimal number from 0–255.
Network Mask	If you are unsure, leave this blank; the printer
	chooses an appropriate mask.
Default Router/Gateway address	Router address is required to communicate with
	the host device from anywhere other than the
	local network segment.

Using the Control Panel

To manually set the IP address:

1.On the control panel, select Printer Setup, and then press the OK button.

2.Select Connection Setup, and then press the OK button.

3.Select Network Setup, and then press the OK button.

4.Select TCP/IP Setup, and then press the OK button.

5.Select DHCP/BOOTP, and then press the OK button to select Off.

6.Select TCP/IP Address, and then press the OK button.

7.Enter the printer’s IP address, and then press the OK button.

Phaser® 4510 Laser Printer

2-7