Xerox 4510 manual Overview of Network Setup and Configuration

Overview of Network Setup and Configuration

Overview of Network Setup and Configuration

To set up and configure the network:

1.Connect the printer to the network using the recommended hardware and cables.

2.Turn on the printer and the computer.

3.Print the Configuration page and keep if for referencing network settings.

4.Configure the printer’s TCP/IP address, which is required to identify the printer on the network.

■Windows operating systems: Run the Installer on the Software and Documentation CD-ROMto automatically set the printer’s IP address if the printer is connected to an established TCP/IP network. You can also manually set the printer’s IP address on the control panel.

■Macintosh systems: Manually set the printer’s TCP/IP address on the control panel.

5.Install the driver software on the computer from the Software and Documentation CD-ROM. For information on driver installation, see the section in this chapter for the specific operating system you are using.

Note: If the Software and Documentation CD-ROMis not available, you can download the latest driver from www.xerox.com/drivers.

See also:

Advanced Features Guide at www.xerox.com/office/4510support

Phaser® 4510 Laser Printer

2-2