100BaseT Ethernet
Before You Connect to a 100BaseT Ethernet Network
The printer Ethernet Interface has speed settings of 10Mbps (10 Megabits per second), 100Mbps (100 Megabits per second) and Auto (AutoSensing).
If your network has hubs or concentrators that have
Before you connect the printer to your network, perform the procedure in the next column on this page entitled
Go to the printer and...
Go to the printer and...
1.Enter the Tools pathway
a)Press the Access ( or ) button.
b)On the keypad enter 1111 or the current password. Press the Enter button when finished. The Touch Screen will be used for the remainder of the data entry, unless instructed otherwise.
2.Set or Change the Ethernet speed.
a)Press the Connectivity and Network Setup button.
b)Wait for the screen to refresh and press the Physical Media button.
NOTE:
c)Select the desired Speed (10Mbps, 100Mbps, or Auto).
d)When finished with your changes press Save.
3.Exit the Tools menu
a)Press the Exit Tools button.
NOTE: At this point the Network Controller is being reset and initializing with the new setup. When complete a Configuration Report will print.
b)Obtain the Configuration Report page from your printer and verify that your settings have been retained.
4.Connect your printer to the network with the appropriate cabling.
5.Select the appropriate Network or Protocol Quick Install Card and continue with the configuration.
11 | 604P14700 |