Microsoft Windows NT 4.0 Server (TCP/IP)
Before You Start
Verify the Ethernet connection is complete and the desired speed is set. Then return to this page.
Your printer has DHCP enabled by default. If you have configured a DHCP server with TCP/IP information, you can connect your printer to your network and it will retrieve its TCP/IP information from the DHCP server when it is turned on.
You can manually assign or use BOOTP or RARP servers to assign TCP/IP information to your printer. Refer to the Dynamic TCP/IP Address Assignment (DHCP/BOOTP/RARP) Quick Install Card for details.
If you are using DHCP, perform Steps 1 through 6c but DO NOT change any values. Then read the note before step 6d and determine if you wish to change the lpr port number. After choosing, complete the remainder of the procedure.
Record the following information:
Host Name ____________________________
IP Address ____________________________
Subnet Mask ___________________________
Default Gateway ________________________
Go to the printer and...
1.Connect your printer to the network with the appropriate cabling
2.Enter the Tools pathway
a)Press the Access (
or 
) button.
b)On the keypad enter 1111 or the current password. Press the Enter button when finished. The Touch Screen will be used for the remainder of the data entry, unless instructed otherwise.
3.Enter the Network Setup menus
a)Press the Connectivity and Network Setup button.
b)Wait for the screen to refresh and press the Network Setup button.
c)Press the TCP/IP Options button.
4.Enable the Protocol and Media
a)Press the TCP/IP Settings button.
b)Press the Protocol and Media button.
c)Press the Enable button.
d)Press Save.
NOTE: The Broadcast Address will be calculated automatically.
5.Set the Host Name
a)Press the Name/Address button.
b)One at a time press the soft buttons on the Touch Screen for each octet of the IP address and enter the numbers using the keypad.
c)Press the Host Name button.
d)When the soft keypad appears, type the host name EXACTLY as you want it to appear with correct case. When finished press the Save button twice to record the changes and exit to the TCP/IP Settings Screen.
6.Set the Subnet Mask and Gateway
a)Press the Subnet and Gateway button.
b)One at a time press the soft buttons on the Touch Screen for each octet of the Subnet Mask and enter the numbers using the keypad.
c)Repeat this process for the IP Gateway address. When finished press Save to record the changes and press Close to exit to the TCP/IP Settings screen.
d)Press the TCP/IP - Line Printer button. At the next screen press the Enable button.
NOTE: While you can change the port number at which your printer will accept lpr print jobs it is recommended that you do this ONLY with extreme caution as most lpr spoolers are set to send print jobs to the default port.
e)If you wish to change the lpr port for your printer press the port soft button and enter the desired port number at the keypad. Press Save.
7.Exit the Tools Menu
a)Press the Exit Tools button.
23 | 604P15300 |
