Port 9100 TCP/IP Printing
Before You Start
Verify the Ethernet connection is complete and the desired speed is set. Then return to this page.
Your printer has DHCP enabled by default. If your DHCP server is configured with the TCP/IP information for the printer, you should skip Steps 5 and 6 on this card and go to Step 7 to enable Port 9100 printing.
If you use RARP or BOOTP to configure your TCP/IP information, use the Dynamic TCP/IP Address
Assignment (DHCP/BOOTP/RARP) Quick Install Card and then return to this card and complete Steps 2 trough 7.
If you wish to configure your TCP/IP information statically, complete ALL Steps on this card.
Record the following information:
Host Name ____________________________
Subnet Mask ___________________________
Default Gateway ________________________
Note: Your printer supports printing from a variety of operating systems that support TCP/IP and now sup- ports Port 9100 (RAW) printing.
Go to the printer and...
1.Connect your printer to the network with the appro- priate cabling.
2.Enter the Tools pathway.
a)Press the Access (
or 
) button.
b)On the keypad enter 1111 or the current password. Press the Enter button when finished. The Touch Screen will be used for the remainder of the data entry, unless instructed otherwise.
3.Enter the Network Setup menus
a)Press the Connectivity and Network Setup button.
b)Wait for the screen to refresh and press the Network Setup button.
c)Press the TCP/IP Options button.
4.Enable the network interface and protocol.
a)Press the TCP/IP Settings button.
b)Press the Protocol and Media button.
c)Press the Enable button.
d)Press Save.
5.Set the Host Name.
a)Press the Name/Address button.
b)One at a time press the soft buttons on the Touch Screen for each octet of the IP address and enter the numbers using the keypad.
c)Press the Host Name button.
d)When the soft keypad appears, type the host name EXACTLY as you want it to appear with correct case. When finished press the Save button twice to record the changes and exit to the TCP/IP Settings Screen.
6.Set the Subnet Mask and Gateway.
a)Press the Subnet and Gateway button.
b)Press the soft buttons on the Touch Screen one at a time for each octet of the Subnet Mask and enter the numbers using the keypad.
c)Repeat this process for the IP Gateway address. When finished press Save to record the changes and exit to the TCP/IP Settings screen.
d)Press Close.
e)If you need to lp or lpr print press the TCP/IP - Line Printer button. Press Enable then press Save.
NOTE: The Broadcast Address will be calculated automatically.
7.Enable Port 9100 printing.
a)Press the RAW TCP/IP printing button.
b)Press the Enable button.
c)Press Save.
8.Exit the Tools Menu
a)Press the Exit Tools button.
31 | 604P15700 |
