Static (Manual) TCP/IP Addressing
9.Enable HTTP/IP.
a)Press the HTTP/IPP button.
b)Press Enable.
c)Press Save
10.Print a Configuration Report.
a)Press the Close button three times
b)Select System Settings.
c)Select Configuration Report.
d)Select Print Configuration Report Now.
e)Press the Cancel button.
11.Exit the Tools menu
a)Press the Exit Tools button.
NOTE: At this point the Network Controller is being reset and initializing with the new setup. When complete a Configuration Report will print.
b)Obtain the Configuration Report page from your printer and verify that your settings have been retained.
12.Prepare for print driver installation
a)From the documentation package supplied with your printer, retrieve the CentreWare Print and Fax Drivers CD and the leaflet entitled Getting Started with Network Services. Proceed to the next section of this procedure called Go to a Workstation and...
Go to a workstation and...
1.Create a test job and send it to the printer with an lpr utility or through a queue your operating system may support.
2.Check your test job for quality and use the problem solving section of the Reference Guide for resolving print defects.
3.If your job does not print, refer to the troubleshooting section in the System Administration Guide (pdf file) located on the Customer Documentation CD to correct the problem.
4.Repeat this Go to a workstation and... procedure at each workstation that will print to this printer.
Setup DNS (if required)
Go to the printer and...
1.Configure DNS
a)Repeat steps 2 through 4a
b)Select the DNS Configuration button.
c)Select the Domain Name Button. Again select the Domain Name Button. Type in the domain name then select Save then select Close.
d)Select the Preferred DNS Server button. Press the soft buttons on the Touch Screen for each octet of the IP address and enter the numbers using the keypad. Select Save.
e)Select the Alternate DNS Server button. For each Alternate Server, Press the soft buttons on the Touch Screen for each octet of the IP address and enter the numbers using the keypad. Select Save.
f)Press the Exit Tools button.
604P14800 | 14 |
