Xerox 96 NPS manual Frequent misfeeds

CLEARING PAPER MISFEEDS AND JAMS

7.Slide the tray back into the printer until the tray latches and press the Continue button to resume printing.

8.Discard any pages sent to the sample tray or unused stacker tray when the paper jam was detected.

Note: If the 96/4635/180 NPS does not continue printing after a paper tray fault or after paper is loaded, open then close the tray. The system should resume printing.

Frequent misfeeds

Frequent misfeeds may be caused by a glazed feed belt, especially if one tray feeds the same kind of paper better than another tray does. (Glazing is caused by a buildup of the chemicals found on most papers.)

If you suspect that the belt is glazed, try cleaning it with film remover obtained from your service representative.

Caution: Clean the feed belt only to correct misfeeds, not as routine maintenance. Because the belt is rubber, frequent cleaning dries it out and makes it fail prematurely.are or software.

1.Clear any misfeeds that have occurred, but do not latch the paper feeder assembly. If necessary, unlatch it by pressing down on the bright green lever on the right side of the paper tray.

2.Lightly moisten a lint-free towel with film remover and thoroughly wipe the outside surface of the feed belt in the same direction as the ribs on the belt. (Wiping from side to side might

XEROX DOCUPRINT 96/4635/180 NPS TROUBLESHOOTING GUIDE 5-3