![](/images/new-backgrounds/1168110/16811037x1.webp)
Connecting the Parallel Cable (XE80, XE82 only)
1.Connect the
2.Connect the
Turn to the Printer Driver Software Installation section in this User Guide to set up the WorkCentre XE for printing.
Connecting the Power Cord
As electricity is always dangerous if not used properly, please take all necessary precautions to prevent electric shocks when connecting and disconnecting the WorkCentre.
If you use the WorkCentre in a country other than the country where the WorkCentre was purchased, you will need to make sure that your local power supply is compatible with your model. If you plug the WorkCentre into an incompatible power supply, irreparable damage to the WorkCentre will result.
1.Check that the power switch for the WorkCentre is in the OFF position. The switch is located on the lower left hand side of the WorkCentre and labeled “O” for OFF and “I” for ON.
2.Connect the power cord to the power cord socket in the rear left hand corner of the WorkCentre, and then plug the other end into a properly- grounded power outlet.
The WorkCentre should only be plugged into a
3.Load paper (refer to Loading Media).
4.Turn on the power switch ON.
10