10. Carefully remove the sheet of black protective paper from the drum cartridge, making sure not to leave any torn pieces of paper in the WorkCentre.
11.Replace the toner cartridge. Hold the
handle of the toner cartridge so that the stamped markings on top of the cartridge are facing upward.
12.Gently insert the toner cartridge inside the WorkCentre.
13. Push where indicated (in the illustration) until the toner cartridge is fully inside the WorkCentre and the handle springs back.
14.Ensure that the WorkCentre power is on. You must hold in the button indicated and close the door at the same time. Continue to hold the button for 3 seconds then release the button. The 3 Copy Contrast LEDs will flash and return to ready state. If the J2 code is still present, repeat the process.
D O C U M E N T
50%
200%
WorkCentr
e
XE80
C
45
