51

Track recording

5
Note
Note
If the input channel is paired, the same settings will be
applied to both channels.
7If you want to adjust the effect, use the

[INPUT SEL] key to select the input channel.

While you produce sound on your instru-

ment, adjust the [EQ] knob, [DYN] knob, or

[EFF 1]/[EFF 2] knobs of the Selected Channel

section.

Immediately after you select an input library, turn-

ing the knobs of the Selected Channel section will

control the following items.

Turning the [EQ] knob......Adjusts the amount of boost/
cut for each EQ band. To select
the band that will be adjusted,
use the [HIGH] key, [HI-MID]
key, [LO-MID] key, or [LOW]
key located at the right.
Turning the [DYN] knob....Simultaneously adjusts multi-
ple dynamics parameters to
adjust the dynamics effect. The
result will depend on the
library that you selected.
Turning the [EFF 1] knob...Adjusts the balance of direct
sound and processed sound
for internal effect 1.
Turning the [EFF 2] knob...Adjusts the balance of direct
sound and processed sound
for internal effect 2.
Note
Note
Depending on the input library you select, the level of
the input channel may change. Re-adjust the volume bal-
ance using the INPUT LEVEL knob in the INPUT SET-
TING popup window.
Tip!
Tip!
If turning the [EQ] knob or [DYN] knob does not produce
the desired result, you can reload new settings from the
EQ library or dynamics library (
p. 77, 78).
8In the same way, select input library settings

for the other input channels.

However, a maximum of two input channels can

use the internal effects at the same time.

Input library
Internal effect
EQ
Dynamics
Speaker
simulator
INPUT LEVEL
to the bus
MIC/LINE
INPUT jack
Input channel