Yamaha AW 16G 3, 4

Mixdown and bounce operations

EParameter page/Return channel page

In this area you can edit the various effect parame-

ters. The content and range of the parameters will

depend on the currently-used effect type.

If the effect is internally connected to the mixer sec-

tion via send/return, this area will show the mix

parameters of the return channel, allowing you to

edit them.

3Move the cursor to the effect parameter that

you want to edit, and turn the [DATA/JOG]

dial to edit the value.

Depending on the effect type, this area may be used

to show multiple parameter pages. In this case,

repeatedly press the CURSOR [ ] key to access

the parameter page that contains the parameter you

want to edit.

For example, the illustration below shows the

parameter pages for the STEREO DELAY effect type.

Tip!

The parameter pages show the parameters that are spe-

ciﬁc to that effect type. However for all effect types, the

lower right of the last parameter page will have a MIX

BAL. parameter which sets the mix balance between the

effect sound and the original sound.

4To edit the mix parameters of the return

channel, access the last parameter page, and

then press the CURSOR [ ] key once again.

If the effect is internally connected to the mixer sec-

tion via send/return, you can repeatedly press the

CURSOR [ ] key to access the mix parameters of

the return channel. The following pages are the

same for all effect types.

1EFF2SEND

Adjusts the level at which the signal is sent from the

return channel to the other internal effect.

Note

You cannot send the signal from return channel 1 to

insert effect 1 (since this would mean sending the signal

back to the same effect itself). For this reason, the EDIT

page of the EFF1 screen has no send level to effect 1. For

the same reason, the EDIT page of the EFF2 screen has no

send level to effect 2.

BAUX1SEND

CAUX2SEND

These adjust the send level of the signal that is sent

from the return channel to AUX buses 1/2.

DEFF2 PRE/POST

Switches the signal that is sent from the return chan-

nel to the other effect bus between pre-fader and

post-fader.

EAUX1 PRE/POST

FAUX2 PRE/POST

These switch the signals that are sent from the

return channel to AUX buses 1/2 between pre-fader

and post-fader.

1EQ HIGH GAIN

BEQ HIGH FREQ

CEQ HIGH Q

DEQ H-MID GAIN

EEQ H-MID FREQ

FEQ H-MID Q

These specify the gain, frequency, and Q for the

HIGH and HI-MID bands of the return channel EQ.

The range of each parameter is the same as in the

EDIT page of the EQ screen.

MIX BAL. parameter

4 5 6

1 3

4 5 6

1 3