93
Mixdown and bounce operations
9

Editing the dynamics parameters

You can perform detailed editing of the dynamics param-
eters in the same way as for the EQ parameters.
1Press an [INPUT SEL] key, a pad 1–4, a
[TRACK SEL] key, or the [STEREO SEL] key to
select the channel whose dynamics parame-
ters you want to edit.
2From the dynamics library, recall the settings
that are closest to what you have in mind.
3Repeatedly press the Selected Channel sec-
tion [DYN] knob or hold down the [DYN]
knob and use the CURSOR [ ]/[ ] keys to
access the EDIT page of the DYN screen.
1ON/OFF button
Switches dynamics on/off.
BTYPE
Indicates the currently selected dynamics type. The
displayed indication has the following meaning.
COMP........................Compressor
EXPAND.....................Expander
GATE..........................Gate
COMPAND-H............Compander (hard)
COMPAND-S.............Compander (soft)
DUCKING................. Ducking
Note
Note
You cannot change the dynamics type in this page. If you
want to use a different type, you must recall library set-
tings that use the desired type.
CResponse curve
This graph indicates the approximate response of
dynamics settings. The horizontal axis of the graph
is the input level, and the vertical axis is the output
level.
DKEYIN SOURCE
Selects one of the following as the trigger signal
(key-in signal) that will control dynamics process-
ing.
SELF........................... The post-EQ signal of the currently
selected channel
LEFT........................... The post-EQ signal of the adjacent
channel to the left
AUX1......................... The signal immediately before the
master send level of the AUX 1 bus
AUX2......................... The signal immediately before the
master send level of the AUX 2 bus
Note
Note
You will not be able to select LEFT if you have selected
input channel 1, pad channel 1, track channel 1, or the
stereo output channel.
Tip!
Tip!
Dynamics settings and operation are linked for paired
channels and for the stereo output channel. In this case,
dynamics processing will operate simultaneously for both
channels if either channel exceeds the threshold level.
EGR (Gain Reduction)
Indicates the amount of gain reduction produced by
the dynamics processor, in a range of –18 dB to
0 dB.
FOutput meter
Indicates the level of the signal after it has passed
through the dynamics processor.
GParameters
Here you can edit the parameters of the dynamics
processor. The type of parameters and their ranges
will differ depending on the dynamics processor
type. For details on the types of parameter and their
function, refer to the appendix.
4Move the cursor to the parameter that you
want to edit, and use the [DATA/JOG] dial to
edit the value.
5To switch dynamics on/off, press the [ENTER]
key.
In the EDIT page, you can press the [ENTER] key to
switch dynamics on/off regardless of the cursor
location.
Please be aware that if you edit even one parameter
in the EDIT page of the DYN screen, the operation
of the Selected Channel section [DYN] knob will
change as follows for that channel.
1 3 7 56
2 4