Track recording
52

Using the EQ library

The EQ library contains EQ settings appropriate for a
variety of instruments. Use these when you want to apply
EQ to an input channel while you record, or when you
want to modify the EQ settings after recalling an input
library.
1Press and hold the [INPUT SEL] key of the
input channel for which you want to use the
input library, to access the INPUT SETTING
popup window.
2Move the cursor to the EQ button in the
screen, and press the [ENTER] key.
The EQ library will appear.
1List
This is the library list. The line surrounded by a dot-
ted line in the middle of the list is the data that is
selected for loading. When you turn the [DATA/
JOG] dial, the data in the list will scroll upward or
downward.
BRECALL button
Move the cursor to this button and press the
[ENTER] key to load the currently selected data.
CEXIT button
Move the cursor to this button and press the
[ENTER] key to close the popup window.
Tip!
Tip!
You can also access the EQ library by pressing the [EQ]
knob of the Selected Channel section. For details, refer to
“Using libraries and scene memories” (
p. 73).
3Turn the [DATA/JOG] dial to select the library
that you want to use, and press the [ENTER]
key.
A popup window will ask you to confirm the library
recall operation.
4Move the cursor to the OK button and press
the [ENTER] key.
The selected library will be loaded.
5Move the cursor to the EXIT button and press
the [ENTER] key.
6If you want to adjust the EQ settings, press
the [HIGH] key, [HI-MID] key, [LO-MID] key,
or [LOW] key of the Selected Channel section
to select the band, and turn the EQ knob to
adjust the amount of boost/cut.
Note
Note
If turning the EQ knob does not change the tone, check
whether EQ may have been turned off for that channel
(
p. 92).
Tip!
Tip!
If necessary, you can also adjust the frequency and Q
parameters of each band. For details, refer to “Using
libraries and scene memories” (
p. 73).
2
3
1