118 Chapter 10—Aux Sends
DM2000 Version 2—Owner’s Manual
Copying Channel Fader Positions to Aux Sends
While Aux Sends are in Variable mode, you can copy all Input Channel fader positions on
one layer to the corresponding Aux Sends.
This is convenient when you wish to send to the musicians monitor signals that have the
same balance setting as the Stereo Out signals.
1Locate the copy source layer button from the Input Channel Layer buttons,
then press and hold down the button.
2Press one of the AUX SELECT [AUX 1]–[AUX 12] buttons to select the desired
Aux Send copy destination.
The confirmation message appears.
3To execute the Copy operation, move the cursor to the [YES] button, then
press [ENTER].
To cancel the Copy operation, move the cursor to the [NO] button, then press [ENTER].
Metering Aux Send Masters
Aux Send Master levels can be metered on the Meter pages. See “Metering” on page 127 for
more information.
Monitoring Aux Send Masters
Aux Send Masters can be assigned to the CONTROL ROOM [ASSIGN 1] or [ASSIGN 2]
button for monitoring. See “Control Room Monitoring” on page 158 for more informa-
tion. Aux 11 and Aux 12 can be monitored via the STUDIO MONITOR OUT (see
page 159).
Attenuating Aux Send Masters
Aux Send Master signals can be attenuated pre-EQ. See “Attenuating Signals” on page 130
for more information.
EQ’ing Aux Send Masters
Each Aux Send Master features 4-band parametric EQ. See “Using EQ” on page 131 for
more information.
Grouping Master EQs
Aux Send Master EQs can be grouped with the EQs of other Output Channels. See “Group-
ing Output Channel EQs” on page 135 for more information.
Note: If you release the button in the LAYER section before you proceed to Step 2, you will be
unable to complete the Copy operation.
Tip: If the copy destination Input Channel has been paired with a vertical partner in another
Layer, the fader position will be copied to the partner’s Aux Send.