Yamaha DM2000 - page 210

210 Chapter 17—Automix

DM2000 Version 2—Owner’s Manual

The SOURCE section enables you to select the copy source Automix. You can select CUR-

RENT (the current Automix) or MEM (any Automix from 1 to 16).

The TIME parameter determines the point to which the speciﬁed data is copied. The num-

ber in parentheses on the right indicates the end point of the copy destination. You can set

the TIME parameter on-the-ﬂy by selecting the TIME button, then pressing [ENTER]. You

can edit the captured timecode value using the Parameter wheel or INC/DEC buttons. Press

[ENTER] to reset the currently-selected digit to “00.”

The CH parameter speciﬁes the channel to which the speciﬁed data will be copied. The

number of destination channels depends on the speciﬁed number of copy source channels.

For example, if Input Channels 1 though 8 are speciﬁed as the source, then the number of

destination channels will be eight (8). Destination channels are contiguous and only the

ﬁrst channel in the range can be speciﬁed. The number in parentheses on the right indicates

the last channel in the copy destination.

You cannot copy from Input Channels to Output Channels. Also, even within Output

Channels, you cannot copy between Aux and Bus channels.

TRIM: The TRIM button trims the speciﬁed Automix data. This Job includes a TRIM

EDIT section below the TIME SETTING section.

The IN parameter determines the amount of time required for the faders to achieve the

speciﬁed trim amount. The OUT parameter determines the amount of time required for

the faders to return to the previous levels. The LEVEL parameter speciﬁes the fader trim

amount in the range of –96 dB to +96 dB.

MOVE/MERGE: This Job features a SOURCE section and a MOVE TO (MERGE TO)

section below the TIME SETTING section. The function of this button changes depending

on the SOURCE section setting. If you select CURRENT (current Automix) in the

SOURCE section, this button becomes the MOVE button, which enables you to move the

speciﬁed range of Automix data to another position. If you select MEM (Automix memo-

ries 1–16) in the SOURCE section, this button becomes the MERGE button, which enables

you to merge the speciﬁed range of Automix data with other Automix data.

The SOURCE section enables you to select the move/merge source Automix. You can select

CURRENT (the current Automix) or MEM (any Automix from 1 to 16).

Time

Trim: –

TRIM IN TRIM OUT

IN OUT

Trimmed data

Existing data