262 Chapter 20—Remote Control
DM2000 Version 2—Owner’s Manual
Configuring MTR Track Arming
You can assign MTR machine tracks to the TRACK ARMING [1–24] buttons as follows.
These assignments are effective only when the TRACK ARMING [MASTER] button indi-
cator is off.
1Use the TRACK ARMING [DISPLAY] button to locate the MTR Track Arming
Configuration page.
2Use the cursor buttons to select the parameters, and use the Parameter
wheel, INC/DEC buttons, and [ENTER] button to set them.
MACHINE CONTROL/DAW CONTROL: When the MACHINE CONTROL option is
on, the MACHINE CONTROL section controls external MMC or P2 machines, regardless
of the layer selection. When the DAW CONTROL option is on, the MACHINE CONTROL
section controls DAWs, regardless of the layer selection.
MACHINE: This parameter is used to specify the MTR machine whose track is to be
armed when each TRACK ARMING button is pressed. Only machines configured as MTRs
on the Machine Configuration page (see page 256) can be selected.
TARGET TRACK: This parameter is used to specify the MTR machine track that is to be
armed when each TRACK ARMING button is pressed.
Configuring Master Track Arming
You can assign Master machine tracks to the TRACK ARMING [1–24] buttons as follows.
These assignments are effective only when the TRACK ARMING [MASTER] button indi-
cator is lit.
1Use the TRACK ARMING [DISPLAY] button to locate the Master Track Arming
Configuration page.