Yamaha DM2000 Setting the Locate Memories, Pre-roll, Post-roll & Roll-back

260 Chapter 20—Remote Control

DM2000 Version 2—Owner’s Manual

machine switches to input monitor and starts recording. At the out point, the machine

switches to playback monitor and stops recording. At the post-roll point, the machine

locates the pre-roll point and then stops. If the [REHEARSAL] button indicator is lit, the

machine goes into Record-Rehearsal mode between the in and out points (i.e., nothing is

recorded).

This button is used to roll back the machine by the amount speciﬁed on the Locate Memory

page (see page 260). If its pressed while the machine is stopped, the machine rolls back the

speciﬁed amount and stops. If its pressed during playback, the machine rolls back the spec-

iﬁed amount and then continues playing.

This button is used to turn Rehearsal mode on and off. Its indicator lights up when

Rehearsal mode is on. In Rehearsal mode, the machine enters Record-Rehearsal mode

instead of actually recording when the [PLAY] and [REC] buttons are pressed together.

Rehearsal mode can also be used with quick punch.

These mutually exclusive buttons are used to select the MTR or Master machines for control

with the LOCATOR section. When the [MTR] button indicator is lit, the LOCATOR section

controls machines set to MTR. When the [MASTER] button indicator is lit, the LOCATOR

section controls machines set to MASTER. See “Conﬁguring Machines” on page 256.

Setting the Locate Memories, Pre-roll, Post-roll & Roll-back

The locate points and the pre-roll, post-roll, and roll-back times can be set as follows.

1Use the LOCATOR [DISPLAY] button to locate the Locate Memory page.

2Use the cursor buttons to select the parameters, and use the Parameter

wheel, INC/DEC buttons, and [ENTER] button to set them.

MACHINE CONTROL/DAW CONTROL: When the MACHINE CONTROL option is

on, the MACHINE CONTROL section controls external MMC machines, regardless of the

layer selection. When the DAW CONTROL option is on, the MACHINE CONTROL sec-

tion controls DAWs, regardless of the layer selection.

LOCATE MEMORY 1–8, IN, OUT, and RTZ: These time values determine the points

that will be located when the LOCATOR [1–8], [IN], [OUT], and [RTZ] buttons are

pressed. Locate points can be speciﬁed in hours, minutes, seconds, and frames, the frame

range being dependent on the frame rate setting on the Time Reference page (see page 201).

These points can also be set on-the-ﬂy, so long as the DM2000 is receiving timecode. To do

this, while holding down the LOCATOR [SET] button, press the [1–8], [IN], [OUT], or

[RTZ] button.