Selecting Channels 239
DM2000 Version 2—Owner’s Manual
Selecting Channels
Channels can be selected as follows.
(Make sure the ENCODER MODE [ASSIGN 4] (INSERT) button indicator is not lit before
proceeding.)
1Use the [SEL] buttons to select channels.
The [SEL] button indicators of selected channels light up. The border of the corresponding
channel strip displays also light up.
2To select multiple channels in each eight-channel block (e.g., 1–8, 9–16, or
17–24), while holding down one [SEL] button, use the [SEL] buttons of the
other channels in the same block to add and remove channels.
The following shortcuts apply.
Assigning Inputs to Channels
Channels can be assigned to input sources as follows. Before starting the steps below, stop
the Pro Tools transport section.
You can view the current input source assignment for each channel on the channel strip dis-
plays by pressing and holding the ENCODER MODE [ASSIGN 1] (INPUT) button.
1Press the ENCODER MODE [ASSIGN 3] (SEND ASSIGN) button.
Its button indicator flashes, and the SELECT ASSIGN section of the display shows “ASGN.”
2Press the ENCODER MODE [ASSIGN 1] (INPUT) button.
Its button indicator lights up, and the channel strip displays show the current input source
for each channel.
3Use the Encoders to select input sources.
The names of the input sources appear on the channel strip displays in abbreviated form.
When you select a source other than the current, the ring of the corresponding channel strip
display flashes.
4To confirm your selection, press the Encoder’s push-switch.
The channel strip display ring stops flashing.
The following shortcuts apply.
You can cancel this function by pressing the [–/DEC] (ESC) button.
To do this... Do this!
Select multiple channels USER DEFINED KEYS [4] + [SEL]
Select all channels USER DEFINED KEYS [5] + [SEL]
Inverse the channel selection USER DEFINED KEYS [13] + [SEL]
To do this... Do this!
Set all channels to the same input
source
ENCODER MODE [ASSIGN 3], ENCODER MODE [ASSIGN 1],
Encoder, USER DEFINED KEYS [5] + Encoder push-switch
Set all selected channels to the same
input source
ENCODER MODE [ASSIGN 3], ENCODER MODE [ASSIGN 1],
Encoder, USER DEFINED KEYS [5] + USER DEFINED KEYS [4] +
Encoder push-switch