240 Chapter 19—Pro Tools Remote Layer
DM2000 Version 2—Owner’s Manual
Assigning Outputs to Channels
Channels can be assigned to output destinations as follows. Before starting the steps below,
stop the Pro Tools transport section.
You can view the current output destination assignment for each channel on the channel
strip displays by pressing and holding the ENCODER MODE [ASSIGN 2] (OUTPUT) but-
ton.
1Press the ENCODER MODE [ASSIGN 3] (SEND ASSIGN) button.
Its indicator flashes, and the SELECT ASSIGN section of the display shows “ASGN.”
2Press the ENCODER MODE [ASSIGN 2] (OUTPUT) button.
Its indicator lights up, and the channel strip displays show the current output destination
for each channel.
3Use the Encoders to select output destinations.
The names of the output destinations appear on the channel strip displays in abbreviated
form. When you select a destination other than the current, the ring of the corresponding
channel strip display flashes.
4To confirm your selection, press the Encoder’s push-switch.
The channel strip display ring stops flashing.
The following shortcuts apply.
You can cancel this function by pressing the [–/DEC] (ESC) button.
Setting Channel Levels
Channel levels can be set as follows.
(Make sure the FADER MODE [FADER] and [AUX/MTRX] button indicators are not
flashing before proceeding.)
1Use the faders to set channels levels.
Faders in a mix group are controlled together. You can temporarily disable a mix group in
order to make adjustments to individual faders by pressing and holding the USER
DEFINED KEYS [12] (CTRL/CLUTCH) button. Alternatively, you can make adjustments
to individual faders while touching the knob of at least one fader in that mix group.
You can view channel levels in dB on the channel strip displays by holding down the USER
DEFINED KEYS [13] (ALT/FINE) button while adjusting faders.
To do this... Do this!
Set all channels to the same output
destination
ENCODER MODE [ASSIGN 3], ENCODER MODE [ASSIGN 2],
Encoder, USER DEFINED KEYS [5] + Encoder push-switch
Set all selected channels to the same
output destination
ENCODER MODE [ASSIGN 3], ENCODER MODE [ASSIGN 2],
Encoder, USER DEFINED KEYS [5] + USER DEFINED KEYS [4] +
Encoder push-switch