Optimizing the speaker setting for your listening room
4Make sure that “SETUP” is set to “AUTO” and the pointer is pointing at “START”.
y
You can also select the following setup methods. In this case, press 7kto select “SETUP”, press 7l / h to select the one of the following choices and then select “START”.
Choices: AUTO, RELOAD, UNDO, DEFAULT
•Select “AUTO” to automatically run the entire “AUTO SETUP” procedure.
•Select “RELOAD” to reload the last “AUTO SETUP” settings and override the previous settings.
•Select “UNDO” to undo the last “AUTO SETUP” settings and restore the previous settings.
•Select “DEFAULT” to reset the “AUTO SETUP” parameters to the initial factory settings.
Note
“RELOAD” or “UNDO” is available only when you have previously run “AUTO SETUP” and confirmed the results.
5Press 7n to select “START” and then press 7ENTER to start the setup procedure.
The following message appears in the OSD.
NOTICE
Loud
Please or
Press
Before proceeding next operation
Once you perform the next operation, this unit starts the automatic setup procedure. For more accurate measurements, keep quiet and move to the wall where speakers are not around. We recommend that you leave the listening room during the automatic setup procedure.
6Press 7ENTER to start the setup procedure.
This unit starts the auto setup procedure. Loud test tones are output from each speaker during the auto setup procedure. Once all items are set, the result display appears in the OSD.
Notes
•During the auto setup procedure, do not perform any operation on this unit.
•We recommend getting out of the room while this unit is in the auto setup procedure. It takes approximately 3 minutes for this unit to complete the auto setup procedure.
This unit performs the following checks:
Speaker wiring/volume level WIRING/LEVEL
Checks which speakers are connected and the polarity of each speaker. Also checks and adjusts the volume level of each speaker.
Speaker distance DISTANCE
Checks the distance of each speaker from the listening position and adjusts the timing of each channel.
Speaker size SIZE
Checks the frequency response of each speaker and sets the appropriate
