Yamaha DSP-AX463 12 En, Before connecting to the SPEAKERS terminal, 1Loosen the knob, 2 1

Connections

■Before connecting to the SPEAKERS

terminal

A speaker cord is actually a pair of insulated cables running side by side. Cables are colored or shaped differently, perhaps with a stripe, groove or ridges.

Connect the striped (grooved, etc.) cable to the “+” (red) terminals of this unit and your speaker. Connect the plain cable to the “–” (black) terminals.

Remove approximately 10 mm (3/8”) of insulation from the end of each speaker cable and then twist the bare wires of the cable together to prevent short circuits.

10 mm (3/8”)

■Connecting to the SPEAKER terminals

2

1

3

Red: positive (+)

Black: negative (–)

1Loosen the knob.

2Insert the bare end of the speaker wire into the hole on the terminal.

3Tighten the knob to secure the wire.

12 En