Optimizing the speaker setting for your listening room

10Press 7n and then press 7l / h to select “SET” or “CANCEL”.

Choices: SET, CANCEL

Select “SET” to confirm the “AUTO SETUP” results.

Select “CANCEL” to cancel the “AUTO SETUP” results.

11Press 7ENTER to confirm your selection.

The top “SET MENU” display appears in the OSD.

SET MENU

TOP MENU

.;AUTO SETUP

;MANUAL SETUP

.A;SIGNAL INFO

[p]/[p]:Up/Down [ENTER]:Enter

12Press KMENU to exit from “SET MENU”.

13Disconnect the optimizer microphone from this unit.

The optimizer microphone is sensitive to heat. Keep it away from direct sunlight and do not place it on top of this unit.

y

If you change speakers, speaker positions, or the layout of your listening environment, run “AUTO SETUP” again to recalibrate your system.

If an error screen appears

Press 7k / n / l / h to select “RETRY” or “EXIT” and then press 7ENTER.

The following display is an example where “E-8:USER CANCEL” appears in the OSD.

ERROR

.E-8:USER CANCEL Can't detect signal at MIC

>RETRY EXIT

[]/[]:Select [ENTER]:Enter

Choices: RETRY, EXIT

Select “RETRY” to retry the “AUTO SETUP” procedure.

Select “EXIT” to exit from the “AUTO SETUP”

procedure.

If “WARNING” appears

When this unit detects potential problems during the “AUTO SETUP” procedure, “WARNING” appears in the result display. Check the warning messages to correct your speaker settings.

Note

Warnings differ from errors in that warnings do not cancel the “AUTO SETUP” procedure.

1Make sure the pointer is pointing at “WARNING” and then press 7ENTER to

display the detailed information about the warning.

The number on the right of “WARNING” indicates the number of warning messages.

AUTO SETUP

.WARNING(2)

RESULT

SP : 3/2/0.1

DIST: 3.2/3.5m

LVL : -2/+2dB

>SET CANCEL

[ ]/[ ]:Up/Down

[ENTER]:Detail

2Press 7l / h repeatedly to toggle between the warning displays.

WARNING

W-1:OUT OF PHASE

Reverse channel

AAAAFLAAAAA---

AAACENTER

AAAASLAAAAA---

[]/[]:Select [ENTER]:Return

y

For details about each warning message, see the “AUTO SETUP” section in “Troubleshooting” on page 67.

When the corresponding warning message is not applicable to a speaker, “– –” is displayed instead.

3Press 7ENTER to return to the result display.

26 En

Page 28
Image 28
Yamaha DSP-AX463 owner manual 26 En, If an error screen appears, If Warning appears, Press 7ENTER to confirm your selection