Yamaha DSP-AX463 owner manual Playback, Basic operations, 32 En, Quick guide to contents

Playback

Caution

Extreme caution should be exercised when you play back CDs encoded in DTS. If you play back a CD encoded in DTS on a DTS-incompatible CD player, you will only hear some unwanted noise that may damage your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the sound output level of your CD player before you play back a CD encoded in DTS.

Basic operations

1Turn on the video monitor connected to this unit.

2Press E SPEAKERS repeatedly to select the front speakers you want to use.

The respective speaker indicators lights up in the front panel display.

3Press J INPUT l / h repeatedly (or press one of the input selector buttons (3)) to select the desired input source.

The name of the currently selected input source appears in the front panel display for a few seconds.

Available input sources

MULTI CH DVR V-AUX DTV/CBL DVD MD/CD-R CD TUNER

USB

Currently selected input source

4Start playback on the selected component.

Refer to the operating instructions for the source component.

5Rotate DVOLUME (or press

LVOLUME +/–) to adjust the volume to the desired output level.

6Press G PROGRAM l / h repeatedly (or press 4AMP and then APROG l / h

repeatedly) to select the desired sound field program.

The name of the selected sound field program appears in the front panel display.

See page 37 for details about sound field programs.

Movie Dramatic

Currently selected

surround field program

Notes

•Choose a sound field program based on your listening preference, not merely on the name of the program.

•When you select an input source, this unit automatically selects the last sound field program used with the corresponding input source.

•Sound field programs cannot be selected when the component connected to the MULTI CH INPUT jacks is selected as the input source (see page 33).

•When PCM signals with a sampling frequency higher than 48 kHz are input, this unit is automatically set to the “STRAIGHT” mode (see page 38).

•To display information about the currently selected input source in the OSD, see page 35 for details.

■A quick guide to contents

When you want to...	See
	page
Enjoy high quality sound	40
Adjust the tonal quality of the front speakers	40
Adjust the parameters of sound field programs	39
Enjoy the sources with a wide dynamic range at night	41
Use headphones	34
Select a decoder to play back sources with	38
Automatically set this unit to the standby mode	36

32 En