
■If an error screen appears
Press 9k / n / l / h to select “RETRY” or “EXIT” and then press 9ENTER.
The following display is an example when
ERROR
.
any function
>RETRY EXIT
[[]/[[]:Select [ENTER]:Enter
Choices: RETRY, EXIT
•Select “RETRY” to retry the “AUTO SETUP” procedure.
•Select “EXIT” to exit from the “AUTO SETUP” procedure.
y
If
Optimizing the speaker setting for your listening room (YPAO)
■If “WARNING” appears
When this unit detects potential problems during the “AUTO SETUP” procedure, “WARNING” appears in the top result display. Check the warning messages to correct your speaker settings.
Note
Warnings differ from errors in that warnings do not cancel the “AUTO SETUP” procedure.
1Make sure the pointer is pointing at “WARNING” and then press 9ENTER to
display the detailed information about the warning.
The number on the right of “WARNING” indicates the number of warning messages.
AUTO
.WARNING(3)
RESULT
SP : 3/4/0.1
DIST: 4.50/5.30m
LVL :
>SET CANCEL
[]/[
]:Up/Down [ENTER]:Detail
2Press 9l / h repeatedly to toggle between the warning displays.
WARNING
Reverse Channel
FL
CENTER |
|
PL | PR |
SL | SR |
SBL | SBR |
[[]/[[]:Select
[ENTER]:Return
y
•For details about each warning message, see the “AUTO SETUP” section in “Troubleshooting” on page 102.
•When the corresponding warning message is not applicable to a speaker,
•If “SWFR: TOO LOUD” or “SWFR: TOO LOW” appears
in the
3Press 9ENTER to return to the top result
display.
PREPARATION
English