
Remote control features
Programming codes from other remote controls
You can program remote control codes from other remote controls. Use the learn feature if you want to program functions not included in the basic operations covered by the remote control codes, or an appropriate remote control code is not available. You can program the function of other remote control to the buttons in the highlighted areas in the following illustration. The buttons can be programmed independently for each control area.
2Place this remote control about 5 to 10 cm (2 to 4 in) apart from the other remote control on a flat surface so that their infrared transmitters are aimed at each other.
| DVD | V | TUNER | 1 |
| TV | POWER |
| AUX/DOCK |
| |||||
|
| - |
|
|
|
|
|
| DVR VCR | DTV/CBL CD | A B | 2 3 | SCENE | AV | POWER STANDBY |
SELECT | PHONO | C | 4 |
|
| POWER |
Other remote control
POWER | POWER STANDBY POWER |
TV | AV |
SCENE
1 2 3 4
TUNER A B C
DVD DVR VCR PHONO
SELECT
AMP
+ + +
SOURCE
TV VOL | TV CH | VOLUME |
– – – TV
LEVEL | PRESET/CH | SET MENU |
|
|
| ||
TITLE |
| MENU | AUDIO |
BAND |
| SRCH MODE |
|
|
|
| PURE DIRECT |
| ENTER |
|
|
|
| A/B/C/D/E |
|
|
|
| STRAIGHT |
RETURN |
| DISPLAY |
|
MEMORY |
|
|
|
CLASSICAL | LIVE/CLUB | ENTERTAIN | MOVIE |
1 | 2 | 3 | 4 |
STEREO | ENHANCER | SUR. DECODE | PARAMETER |
5 | 6 | 7 | 8 |
MULTI CH IN |
|
| SLEEP |
9 | 0 | +10 | ENT |
INFO | EON | MODE- PTY SEEK- START | |
REC |
|
|
|
OFF ON MACRO LEARN CLEAR RENAME
5 to 10 cm
3Press CLEARN using a ballpoint pen or similar object.
“LEARN” and the name of the selected control area (e.g. “DVD”) appear alternately in the display window (6) on the remote control.
TV MUTE | TV INPUT | MUTE |
Note
The remote control transmits infrared rays. If the other remote control also uses infrared rays, this remote control can learn most of its functions. However, you may not be able to program some special signals or extremely long transmissions. Refer to the operating instructions for the other remote control.
1Set the operation mode selector to
FSOURCE and then press an input selector button (5) to select a an control area.
Note
Make sure that the operation mode selector is set to
FSOURCE. When you set the operation mode selector to FAMP and program a remote control codes from other remote controls, the programmed key cannot operate the amplifier function of this unit.
LEARN
Notes
•Do not press and hold CLEARN. If you hold it down for more than 3 seconds, the remote enters the remote control code setting mode.
•If you do not complete each of the following steps within 30 seconds, the learning mode will be automatically canceled. In this case, start over from step 3.
4Press the button for which you want to program the new function.