
Clearing configurations
You can clear all changes made in each function set, such as learned functions, macros, renamed control area names and setup remote control ID.
■Clearing function sets
1Set the operation mode selector to FAMP or FSOURCE and then press CCLEAR by
using a ballpoint pen or similar object.
“CLEAR” appears in the display window (6).
AMP
SOURCE
TV
CLEAR
or
AMP
SOURCE
TV
Note
If you do not complete each of the following steps within 30 seconds, the clearing mode will be automatically canceled. In this case, start over from step 1.
2Press 9k / n to select the clear mode.
L;CD (etc.) (L; Name of an control area)
Clears all learned functions in the respective
| control area. The name of a component is |
| shown after a semicolon (;). Press an input |
| selector button to select the control area. |
L;AMP | Clears all learned functions for controlling the |
| amplifier functions of this unit. |
L;ALL | Clears all learned functions. |
M;ALL | Clears all programmed macros. |
RNAME | Clears all renamed source names. |
FCTRY | Clears all remote functions and returns the |
| remote to the factory settings. |
Remote control features
3Press and hold CCLEAR again for about 3 seconds.
“WAIT” appears in the display window (6). If clearing was successful, “C;OK” appears in the display window (6) on the remote control.
CLEAR
y
Once you have cleared a learned function for a button, the button reverts to the factory setting (or to the manufacturer setting, if you have set remote control codes).
Notes
•“L;ALL” and “FCTRY” may take about 30 seconds to complete.
•“C;NG” appears in the display window (6) if clearing was unsuccessful. In this case start over from step 2.
•“ERROR” appears in the display window (6) if you press a button not indicated in the respective step, or if you press more than one button simultaneously.
OPERATION | ADVANCED |
|
|
English