
Troubleshooting
■Remote control
Problem | Cause | Remedy | See | |
page | ||||
|
|
| ||
The remote control | Wrong distance or angle. | The remote control will function within a maximum | 30 | |
does not work or |
| range of 6 m and no more than 30 degrees |
| |
function properly. |
| from the front panel. |
| |
|
|
|
| |
| Direct sunlight or lighting (from an | Reposition this unit. | — | |
| inverter type of fluorescent lamp, etc.) is |
|
| |
| striking the remote control sensor of this |
|
| |
| unit. |
|
| |
|
|
|
| |
| The batteries are weak. | Replace all batteries. | 4 | |
|
|
|
| |
| The operation mode selector is set | Set the operation mode selector correctly. | — | |
| incorrectly. | When operating this unit, set it to the FAMP |
| |
|
| position. When operating the component selected by |
| |
|
| the input selector button, set it to the FSOURCE |
| |
|
| position. When operating the TV set in the |
| |
|
| 5DTV/CBL or 5PHONO area, set it to the FTV |
| |
|
| position. |
| |
|
|
|
|
The remote control code was not correctly set.
Set the remote control code correctly using | 84 |
“List of remote control codes” at the end of this |
|
manual. |
|
|
|
Try setting another code of the same manufacturer | 84 |
using “List of remote control codes” at the end of this |
|
manual. |
|
| The library code of the remote control and | Match the remote control ID of this unit with the | 95 | |
| the remote control ID of this unit do not | corresponding remote control library code. |
| |
| match. |
|
| |
|
|
|
| |
| Even if the remote control code is | Program the necessary functions independently into | 86 | |
| correctly set, there are some models that | the programmable buttons using the Learn feature. |
| |
| do not respond to the remote control. |
|
| |
|
|
|
| |
The remote control | The batteries of this remote control and/or | Replace the batteries. | 4 | |
does not learn new | the other remote control are too weak. |
|
| |
functions. |
|
|
| |
The distance between the two remote | Place the remote controls at the proper distance. | 86 | ||
| ||||
| controls is too much or too little. |
|
| |
|
|
|
| |
| The signal coding or modulation of the | Learning is not possible. | — | |
| other remote control is not compatible |
|
| |
| with this remote control. |
|
| |
|
|
|
| |
| Memory capacity is full. | Delete other unnecessary functions to make room for | 92 | |
|
| the new functions. |
| |
|
|
|
|