E
w q
EJU00432a
Water separator
1)Check the water separator to see if there is any water in this separator. This water separator retains any water entering through the fuel tank breather pipe if the Vehicle is cap- sized.
Normally this water separator is empty. (No water)
2)If water remains in this water separa- tor, drain it by removing the drain screw.
Do not forget to reinstall the drain screw securely.
1Water separator
2 Drain screw
EJU00433a
Bilge
Excessive water in the engine compartment bilge can splash into the carburetor and engine. This could cause engine dam- age. If there is any moisture in the bilge, raise the bow about 30 cm (12 in.) and remove the hull drain plugs. After the water has drained, wipe the bilge with dry rags. Reinstall the drain plugs.
cC
Tighten two hull drain plugs securely before launching the Water Vehicle. Clean any foreign material, such as dirt or sand, from the threads before installing the drain plugs.
w
Always properly dispose of gasoline (petrol) soaked rags. They can spontaneously ignite.