Yamaha HTR-5960 owner manual Setting the remote control code, Remote Control Code Default Settings

Setting the remote control code

You can control your TV and other components by setting the appropriate remote control code for each input source. For a complete list of available remote control codes, refer to “LIST OF REMOTE CONTROL CODES” at the end of this manual.

The following table shows the default component in the “Library (component category)” column and the remote control code for each input source.

Remote Control Code Default Settings

Input	Library		Default
	(component	Manufacturer
source			code
	category)
CD	CD	YAMAHA	61907
MD/CD-R	MD	YAMAHA	70888
XM	TUNER	YAMAHA	81918
DVD	DVD	YAMAHA	40539
DTV/CBL	–	–	–
TUNER	TUNER	YAMAHA	81916
V-AUX	–	–	–
DVR	DVR	YAMAHA	51544
VCR	–	–	–
PHONO	–	–	–

Note

You may not be able to operate your YAMAHA component even if a YAMAHA remote control code is initially set as listed above. In this case, try setting other YAMAHA remote control codes.

REMOTE CONTROL FEATURES

1Press one of the input selector buttons to select the component you want to set up.

MDSLEEP

CD CD-R XM

CBL MULTI CH IN

DVD DTV TUNER

PHONO

V-AUX DVR VCR

2Press CODE SET using a ballpoint pen or a similar object.

The TRANSMIT indicator on the remote control flashes twice.

TRANSMIT

CODE SET

Flashes

3Press the numeric buttons (0 to 9) to enter the five-digit remote control code for the component to be used.

The TRANSMIT indicator on the remote control flashes twice, and the remote control code for the selected component is set.

STEREO	MUSIC	ENTERTAIN	MOVIE
1	2	3	4
			TRANSMIT
STANDARD	SELECT	EXTD SUR. PURE DIRECT

5 6 7 8

Flashes

SPEAKERS	ENHANCER	NIGHT	STRAIGHT
9	0	10	ENT.
			EFFECT

y

Refer to “LIST OF REMOTE CONTROL CODES” at the end of this manual.

Notes

•If the manufacturer of your component has more than one code, try each of them until you find the correct one.

•If you do not press any buttons within 30 seconds in step 3, the setup process is canceled. If this happens, repeat the setup procedure.

•If you enter the code number “9980”, the remote control code previously set for the selected component is cleared.

OPERATION ADVANCED

101