Yamaha HTR-5960 After AUTO SETUP, W-1:OUTOF PHASE, W-2:OVER24m 80ft, W-3:LEVELERROR, Notes

TROUBLESHOOTING

After AUTO SETUP

Warning message	Cause	Remedy	See
			page

W-1:OUT OF PHASE	Speaker polarity is not correct. This
	message may appear depending on the
	speakers even when the speakers are
	connected correctly.

Check the speaker connections for proper

polarity (+ or –).

13

W-2:OVER 24m (80ft)	The distance between the speaker and the	Bring the speaker closer to the listening	—
	listening position is over 24 m (80 ft).	position.
W-3:LEVEL ERROR	The difference of volume level among	Readjust the speaker installation so that all	—
	speakers is excessive. (No level correction	speakers are set in locations with similar
	is made.)	conditions.
		Check the speaker connections.	13
		Use speakers of similar quality.	—
		Adjust the output volume of the subwoofer.	33

Notes

•If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.

•If warning “W-1” appears, corrections are made, but they may not be optimal.

•If warning “W-2” or “W-3” appears, no corrections are made.

•If error “E-10” occurs repeatedly, please contact a qualified YAMAHA service center.

INFORMATION ADDITIONAL

113