Yamaha RX-V1065 owner manual Preparation, _%,._, 1Take off the battery compartment cover

PREPARATION

1Take off the battery compartment cover.

2Insert the two supplied batteries (AAA, R03, UM-4) according to the polarity markings (+ and -) on the inside of the battery compartment.

3Snap the battery compartment cover back into place.

•Change all batteries if you notice the following conditions:

-the operation range of the remote contrnl narrows

-the transmit indicator does not flash or is dim

•Do not use old batteries together with new ones.

This may shorten the lilb nf the new batteries or cause old batteries to leak.

•Do not use diflereut types of batteries (such as alkaline and

manganese batteries) together. Specification of batteries may be

diflbrent even though they look the same.

•lfyou lind leaking batteries, discard the batteries immediately,

taking care not to touch the leaked material. If the leaked material

comes into contact with your skin or gets into your eyes or month,

rinse it away immediately and consult a doctor. Clean the battery

compartment thoroughly befnre installing new batteries.

•Dispose of the nld batteries correctly in accordance with your local regulations.

•lfthe remote control is without batteries lor more than 2 minutes,

or if exhausted batteries remain in the remote control, the contents

of the memory may be cleared, lu such a case, install new batteries

and set the remote control code.

The remote control transmits a directional infrared ray. Be sure to aim the remote control directly at the remote control sensor on this unit during operation.

Remote control sensor window

within 6 m (20 ft)_/30 o I 30 °

•Do not spill water or other liquids on the remote control.

•Do not drop the remote control.

•Do not leave or store the remote control in the following conditions:

-places of high humidity, such as near a bath

-places of high temperatures, such as near a heater or stove

-places of extremely low temperatures

-dusty places

_%,._

• You can operate external components with this remote control by setting

the remote control code (page 63).

!

9En