Yamaha RX-V1065 owner manual 12En, Connecting speaker cables, Using bi-amplificationconnections

tl,llll I:i,'I(I,Ii i_

Caution

*A speaker cable is a pair of insulated cables running side by side in general. One of the cables is colored differently or striped to indicate a polarity. Connect one end of the colored/striped cable to the "+" (red) terminal of this unit and the other end to that of your speaker, and connect one end of the other cable to the "-" (black) terminal of this unit and the other end to that of your speaker.

*Before connecting the speakers, be sure to disconnect the power cable.

*Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or

speakers. If the circuit shorts out, "CHECK SP WIRES !" appears on the front panel display when this unit is turned

on.

*If images on the monitor (CRT) are distorted, place the speakers away from the video monitor. If it does not work, use magnetically shielded speakers.

*Use speakers with an impedance of 6-ohm or larger. Set speaker impedance in the advanced setup menu before connecting the speakers (page 64). You can also use 4-ohm speakers as the front speakers when you set "SP IMP." to "6DMIN".

Connecting speaker cables • Using bi-amplification connections

1Remove approximately 10 mm (0.4 in)of insulation from the end of each speaker cable and then twist bare wires of the cable

together so that they will not cause a short circuits.

You can make bi-amplification connections to one speaker system which supports bi-amplification connection as shown below. To activate the connections, set "BI-AMP" to "ON" in the advanced setup menu (page 64).

Front speakers

Right Left

10 mm (0.4 in)i t

Loosen the knob, insert the twisted bare wires into the hole and then tighten the knob.

2/

Red: positive (+)

Black: negative (-)

i3

Connecting the banana plug (Except Korea, U.K., Europe, Russia and Asia models)

Tighten the knob and then insert the banana plug into the end of the terminal.

Banana plug

Caution

Before making bi-amplification connections, remove any brackets or cables that connect a woofer with a

tweeter. Refer to the instruction manuals of speakers for details.

When not making bi-amplification connections, make sure that the brackets or cables are connected before

connecting the speaker cables.

•You cannol use surround back speakers or exlra speakers {presence and Zone2 speakers) when bi-amplificalion conneclions are made.

12En