Yamaha RX-V1065 Natural, Flat, Front, Speaker Config, Distance Min / Max, Level Min / Max

When the speakers are connected to EXTRA SP terminals, press [_Cursor A repeatedly to select "Extra Speaker Assignment" and then press _]Cursor <1 / b> to select how to use EXTRA SP terminals from "Zone2", "Presence" or "None".

If this unit does not work when you press _]Cursor,

press [j_]ON SCREEN once and then operate this unit.

To select sound characteristics for

adjustment, press [_Cursor _7to select "EQ

Type" and then press _]Cursor <1 It>.

If this unit does not work when you press [j_]Cursor, press [j_]ON SCREEN once and then operate this unit.

This unit has a parametric equalizer that adjusts the output levels for each frequency range. The equalizer is adjusted to produce a cohesive sound field based on automatically measured speaker characteristics.

In "EQ Type", you can select the following parametric equalizer characteristics suitable for the desired sound characteristics.

Natural

This adjusts all speakers to achieve natural sound. Select this if sounds in the high frequency range seem too strong when "EQ Type" is set to "Flat".

Flat

This adjusts each speaker to obtain the same characteristics. Select this if your speakers have similar qualities.

Front

This adjusts each speaker to obtain the same characteristics as the front left and right speakers. Select this if your front left and right speakers have significantly better qualities than the other speakers.

Press _]Cursor V to select "Start" and then

press _]ENTER to start the setup procedure.

A countdown starts and a measurement starts in 10

seconds. A loud test tone is output during measurement.

• During the automatic setup procedure, do not perli3rln any

operation on this unit.

• Press [_Cursor A to cancel the automatic setup procedure.

Measurement takes about 3 minutes. To obtain precise results, stay where you will not disturb the measurement, such as to the side of or behind the speakers or outside the room.

When measurement is successfully completed, "YPAO Complete" appears on the front panel display and the measurement result appears on the GUI screen.

Speaker Config

Displays the number of speakers connected to this unit in

the following order:

Total of Front and Center/Total of Surround and Surround Back/Subwoofer

Distance (Min / Max)

Displays the speaker distance from the listening position in the following order:

Closest speaker distance/Farthest speaker distance

Level (Min / Max)

Displays the speaker output levels in the following order: Lowest speaker output level/Highest speaker output level

•lf"Error" appears on the GU1 screen during "Auto Setup", measurement is canceled and the type of error is displayed. For details, see "When an error message is displayed during measurement" (page 21).

•If problems occur during measurement, "Check xx warning(s)" (xx indicates the number of warnings) appears in red. For details, see "When a warning message is displayed after measurement" (page 21).

7Press _]ENTER to confirm the settings.

The speaker characteristics are adjusted according to measurement results.

To cancel the operation, press [j_]Cursor <:1/ t:> to select "Cancel" and press _]ENTER.

When the following screen appears, remove the optimizer microphone. "Auto Setup" is now complete.

The optimizer microphone is sensitive to heat. Store it in a cool place and away from direct sunlight after measurement. Do not leave it in a place where it will be subjected to high temperatures such on an AV component.

•lfyou do not want to apply the measurement results, select "Cancel".

•Perlorm "Auto Setup" again ifynu change the ]mmber or positions of speakers.

•lfyou press I_ENTER belore removing the optimizer microphone, "Auto Setup" of "Speaker Setup" in the Setup menu (page 55) is displayed.

20En