Yamaha RX-V1065 owner manual 2Press @MAIN ZONE ON/OFF or, Assembling the AM loop antenna, 18En

I_qllll_i(l'lff

An indoor FM antenna and an AM loop antenna are supplied with this unit. Connect these antennas properly to the respective jacks.

Indoor FM antenna	Outdoor AM antenna	AM loop
	Connect a 5 to 10 m (16 to	antenna

and extend it outdoors

33 ft) vinyl-covered wire, (use the AM loop antenna

itogether with this antenna).

Ground (GND terminal)

The GND terminal is not for earth grounding. To reduce noises, connect a ground bar or a vinyl-covered wire with a copper plate at its tip, and place it in the moist ground.

•The supplied amenuas are normally sensitive enough to obtain gnod reception.

•Position the AM loop antenna away fl'om this unit.

•lfynu canuot get good reception, we recommend that you use an outdoor antenna. For details, cousult the nearest authorized Yamaha dealer or service center.

•Always use the AM lnop antenna even when the outdonr antenna is conuected.

Assembling the AM loop antenna

Connecting the AM loop antenna

The wires of the AM loop antenna have no polarity. You can connect either wire to the AM terminal and the other

to the GND terminal.

Press and hold Insert Release

After all connections are complete, plug the power cable of this unit into an AC wall outlet.

To the AC wall outlet

1Press @MAIN ZONE ON/OFF on the front

panel (or []POWER on the remote control) to turn on this unit.

2Press @MAIN ZONE ON/OFF (or

[]POWER) again to turn off this unit (standby mode).

-_,._

•The trait needs a few seconds until ready to play hack.

•Yuu can also turn on lhis unit by pressing @SCENE (or [}{]SCENE).

•This unit consumes a small amount of electricity even ill the standby mode. We recommend discnnuecling the power cable from the AC wall outlet.

Caution

Do not unplug this unit while it is turned on. Doing so may damage this unit or cause the settings of this unit to be saved incorrectly.

18En