12 3 4 5 6 7 8 9 10 Automatic speaker setup

Warning messages

If a warning message is displayed after the measurement, you can still save the measurement results by following on-screen instructions. However, we recommend you perform YPAO again in order to use the unit with the optimal speaker settings.

 

 

 

 

 

 

 

 

 

A u t o S e t u p

 

M e a s u r e m e n t

 

 

 

 

S t a r t

 

F i n i s h e d

 

 

 

 

 

Result

 

 

 

 

E x i t

 

 

 

 

 

 

3 / 2 / 0.1 ch

 

 

 

 

 

 

 

 

 

 

 

 

3.0 / 10.5 m

 

 

 

 

 

 

-3.0 / +10.0 dB

 

 

 

 

 

 

OK:ENTER

 

 

Warning

 

 

 

 

 

 

 

 

 

 

W-1:Out of Phase

 

 

 

 

 

 

 

 

message

 

 

 

 

 

 

 

 

TV screen

Problem speaker (blinks)

 

 

 

 

 

 

VOL.

 

 

 

W-1:PHASE

 

 

SW

 

L

C

R

 

 

 

SL

 

SR

 

 

 

 

 

Front display

Warning message

Cause

Remedy

 

 

 

 

 

Check the cable connections (+/-) of the problem speaker. If

 

 

the speaker is connected incorrectly, exit YPAO, turn off the

W-1:Out of Phase

A speaker cable may be connected with the

unit, and then reconnect the speaker cable.

(W-1:PHASE)

reverse polarity (+/-).

Depending on the type of speakers or room environment, this

 

 

message may appear even if the speakers are connected

 

 

correctly. In this case, you can ignore the message.

 

 

 

W-2:Over Distance

A speaker is placed more than 24 m (80 ft)

Exit YPAO, turn off the unit, and place the problem speaker

(W-2:DISTANCE)

from the listening position.

within 24 m (80 ft) of the listening position.

 

 

 

 

 

Check the usage environment and cable connections (+/-) of

W-3:Level Error

There are significant volume differences

each speaker, and the volume of the subwoofer. If there is

any problem, exit YPAO, turn off the unit, and then reconnect

(W-3:LEVEL)

between the speakers.

speaker cable or correct the speaker positions. We

 

 

recommend using the same speakers or speakers with

 

 

specifications that are as similar as possible.

 

 

 

• Texts in parentheses denote indicators on the front display.

■Procedure to handle warnings

1Check the content of warning message and press ENTER.

2Use the cursor keys (e/r) to select the desired operation.

To save the measurement results:

Select “SAVE” and press ENTER.

To discard the measurement result:

Select “CANCEL” and press ENTER.

3Disconnect the YPAO microphone from the unit.

PREPARATIONS ➤ Optimizing the speaker settings automatically (YPAO)

En 34