Configuring the system settings (ADVANCED SETUP menu)
Configure the system settings of the unit while viewing the front display.
1Set the unit to standby mode.
2While holding down STRAIGHT on the front panel, press z(power).
z(power)
PROGRAM 
STRAIGHT
3Press PROGRAM to select an item.
4Press STRAIGHT to select a setting.
5Press z(power) to set the unit to standby mode and turn it on again.
The new settings take effect.
Item | Function | Page | |
|
|
| |
SP IMP. | (U.S.A. and Canada models only) | ||
Changes the speaker impedance setting. | |||
|
| ||
|
|
| |
REMOTE ID | Selects the unit’s remote control ID. | ||
|
|
| |
TU | (Asia and General models only) | ||
Changes the FM/AM tuning frequency setting. | |||
|
| ||
|
|
| |
TV FORMAT | Switches the video signal type of HDMI output. | ||
|
|
| |
INIT | Restores the default settings. | ||
|
|
| |
UPDATE | Updates the firmware. | ||
|
|
| |
VERSION | Checks the version of firmware currently installed on the unit. | ||
|
|
|
(U.S.A. and Canada models only)
SPIMP.8
MIN
Change the unit’s speaker impedance settings depending on the impedance of the speakers connected.
Settings
6 | Ω MIN | Select this option when you connect | |
can also use | |||
|
| ||
|
|
| |
8 | Ω MIN (default) | Select this option when you connect | |
unit. | |||
|
| ||
|
|
|
REMOTEIDID1
Change the unit’s remote control ID so that it matches the remote control’s ID (default: ID1). When using multiple Yamaha AV receivers, you can set each remote control with a unique remote control ID for its corresponding receiver.
Settings
ID1 (default), ID2
■Changing the remote control ID of the remote control
1 To select ID1, while holding down the cursor key (e), hold down SCENE (BD/DVD) for more than 3 seconds.
To select ID2, while holding down the cursor key (e), hold down SCENE (TV) for more than 3 seconds.
• The registered remote control codes (p.85) are not cleared even if you change the remote control ID.
CONFIGURATIONS ➤ Configuring the system settings (ADVANCED SETUP menu) | En 83 |
|
|