Yamaha YSP-1000 Bbeam Level, Csubwoofer Set, BEAM LEVEL Beam level, SUBWOOFER SET Subwoofer set

■BEAM LEVEL (Beam level)

Use to manually balance the speaker levels between the front left or surround left speakers and each speaker selected.

When setting the front right, center or surround left speakers or the subwoofer, the test tone is output from the front left speakers and the selected speaker position. When setting the surround right speaker, the test tone is output alternately from the surround left and right speakers.

The factory default value is automatically set for this parameter depending on the parameters set in AUTO SETUP, BASIC SETUP or ROOM EQ in MANUAL SETUP.

Depending on the beam mode settings, some channels may not be available for selection. In this case, NONE is displayed.

B)BEAM LEVEL

.

*OUT : FL )FR

*MODE: 5 BEAM

[p p p p

[ENTER]:Return

• FR adjusts the balance of the front left and front right speakers.

• C adjusts the balance of the front left and center speakers.

• SL adjusts the balance of the front left and surround left speakers.

• SR adjusts the balance of the surround left and surround right speakers.

• SWFR adjusts the balance of the front left speaker and subwoofer.

MANUAL SETUP

■SUBWOOFER SET (Subwoofer set)

Use to manually adjust various subwoofer settings.

C)SUBWOOFER SET

. ;;;;;FRONT

;;;120Hz

;;;;-20dB

;;;;;15.0m

[p p p p

BASS OUT (Bass out)

Low-frequency (bass) signals can be directed to the subwoofer or the front left and right speaker positions. This setting also determines the routing of LFE (low- frequency effect) signals found in Dolby Digital or DTS sources.

Choices: SWFR (subwoofer), FRONT

•Select SWFR if you connect a subwoofer. LFE and low-frequency signals from other channels are directed to the subwoofer according to the speaker settings.

•Select FRONT if you do not use a subwoofer. LFE and low-frequency signals from other channels are directed to the front speakers according to the speaker settings (even if you have previously set the front speakers to SMALL).

CROSS OVER (Cross over)

When BASS OUT is set to SWFR, you can use this feature to select a cross-over (cut-off) frequency for all low-frequency signals. All frequencies below the selected frequency will be sent to the subwoofer speaker position. Choices: 80Hz, 100Hz, 120Hz

LFE LEVEL (Low-frequency effect level)

Select to adjust the output level of the LFE (low-frequency effect) channel according to the capacity of your subwoofer. The LFE channel carries low-frequency special effects which are only added to certain scenes. This setting is effective only when this unit decodes Dolby Digital or DTS signals.

Choices: –20 to 0 dB

DISTANCE (Distance)

Select to adjust the distance of the subwoofer from the listening position.

Choices: 0.3 to 15.0 m

Initial setting: 3.0 m

OPERATION ADVANCED

English

75