REMOTE CONTROL FEATURES
In addition to controlling this unit, the remote control can also operate other A/V components made by YAMAHA and other manufacturers. To control other components, you must set up the remote control with the appropriate remote control codes.
Note
Depending on the external A/V component you are using, you may not be able to operate the component with the remote control, even if a remote control code is set. In this case, operate the component using the supplied remote control.
Setting remote control codes
You can control other components by setting the appropriate remote control codes. Codes can be set up for each input area (TV, STB, DVD, VCR and AUX).
For a complete list of available remote control codes, refer to “LIST OF REMOTE CONTROL CODES” at the end of this manual.
DVD VCR STB TV
TV
INPUT1 INPUT2 MACRO
AUX
(
) INPUTMODE SLEEP
YSP
1While holding down CODE SET, press the input selector button for the component you want to set up and then without releasing CODE SET, enter the remote control code using the numeric buttons.
The following illustrations show an example of setting the remote control code for a DVD player made by YAMAHA.
Setting example: YAMAHA DVD input area
| 6 |
TV MUTE |
|
While holding | VOL MODE |
5BEAM ST+3BEAM
1 2
STEREO TARGET
4 5
MUSIC MOVIE
7 8
SPORTS OFF
0+10
3BEAM
3
6
VOL MODE
9
SURROUND
down, press | DVD | 9 |
|
CODE SET
VOL MODE 9
2 Refer to “Controlling other components” on |
CH LEVEL | CINEMA DSP | MENU |
ENTER
TESTRETURN
VOLUME | CH | TV VOL |
page 88 to operate the external component |
using the remote control. |
If the external component functions correctly, the |
remote control code setup was successful. |
If the external component does not function correctly, |
the remote control code may be incorrect. Confirm |
that the remote control code is correct (see “LIST OF |
REMOTE CONTROL CODES” at the end of this |
manual) and start over from step 1. |
MUTE TV INPUT TV MUTE | Note |
|
CODE SET
If the manufacturer of your component has more than one code, try each of them until you find the correct one.
If the remote control is without batteries for more than 2 minutes, or if exhausted batteries remain in the remote control, the contents of the memory may be cleared. When the memory is cleared, insert new batteries and reset the remote control codes.
When changing the batteries, be careful not to press any of the buttons on the remote control. Doing so will clear the contents of the memory.
English
87
