AHORIZONTAL ANGLE 1/5, 77 En, Notes

•Select ANGLE TO WALL OR CORNER if this unit is installed in the corner of your listening room. Adjust the width and length of your listening room as well as the distance of the listening position from this unit.

Listening position from the unit

Room width

MANUAL SETUP

■BEAM ADJUSTMENT (Beam adjustment)

Use to manually adjust the various sound beam settings. We recommend that you select 5 Beam as the beam mode before adjusting these parameters (see page 56).

Notes

•When INSTALLED POSITION is adjusted in MANUAL SETUP (see page 76), the factory default value is automatically set for this parameter except Center in FOCAL LENGTH (see page 78).

•Depending on the beam mode settings (see pages 56, 57, 62 and 63), some channel positions may not be available for selection. In this case, “– –” is displayed. When using Stereo plus 3 Beam as the beam mode, set the surround left and right signals to be output from the front left and right channels.

Room length		B)BEAM ADJUSTMENT
Choices for the room width and length:		B)BEAM ADJUSTMENT
Choices for the room width and length:	.	a)HORIZONTAL ANGLE
2.0 m to 12.0 m (6.5 ft to 40.0 ft)	.	a)HORIZONTAL ANGLE
2.0 m to 12.0 m (6.5 ft to 40.0 ft)		b)BEAM TRAVEL LENGTH
Choices for the listening position from this unit:		c)FOCAL LENGTH
Choices for the listening position from this unit:		d)TREBLE GAIN
1.8 m to 9.0 m (6.0 ft to 30.0 ft)		[p]/[p]:Up/Down
		[ENTER]:Enter

	A)SETTING PARAMETERS 2/3

		----- 5.4m ---
Room width and
Room width and		[ 5.4m ]
length		[ 5.4m ]
length

	[p]/[p]:Up/Down [p]/[p]:Sel
		[ENTER]:Return

HORIZONTAL ANGLE (Horizontal angle)

Use to adjust the horizontal angle of sound beams for each channel. By adjusting the horizontal angle of the sound beams, you can optimize the sound beam paths. A test tone is automatically output.

Listening position from the unit

A)SETTING PARAMETERS 3/3

[ 2.5m ]

[p]/[p]:Up/Down [p]/[p]:Sel [ENTER]:Return

( )	(+)
(+)	( )

Choices: L90° to R90°

Adjust toward L (left) to move the direction of the output to the left and adjust toward R (right) to move it to the right.

OPERATION	ADVANCED

Note

When you set the INSTALLED POSITION parameter in MANUAL SETUP (see page 76), the parameters newly set for the width and length of your listening room are automatically set as the factory default value.