Yamaha YSP-3050 35 En, Error messages for AUTO SETUP, Before the AUTO SETUP procedure starts

AUTO SETUP (IntelliBeam)

■Error messages for AUTO SETUP

Before the AUTO SETUP procedure starts

Error message	Cause	Remedy	See
			page
ERROR E-2	The IntelliBeam microphone is not	Connect the IntelliBeam microphone to	30
No MIC detected. Please check	connected to this unit.	this unit.
MIC connection and re-try.

While the AUTO SETUP procedure is in progress

If one of the errors listed below except E-1 is displayed, press RETURN. In case you have started the AUTO SETUP procedure by pressing AUTO SETUP in step 3, run the procedure again from step 3 after the screen disappears. In case you have started the AUTO SETUP procedure by pressing MENU in step 3, run the procedure again from step 4 after the screen in step 3 is displayed. Run MANUAL SETUP if the problem is difficult to be solved.

Error message	Cause	Remedy	See
			page
ERROR E-1	There is too much unwanted noise in	Make sure that your listening room is as	—
Please test in quieter environment.	your listening room.	quiet as possible. You may want to
		choose certain hours during the day
		when there is not much noise coming
		from outside.
ERROR E-2	The IntelliBeam microphone was	Make sure that the IntelliBeam	30
No MIC detected. Please check	disconnected while the AUTO SETUP	microphone is firmly connected to this
MIC connection and re-try.	procedure was in progress.	unit.
ERROR E-3	Some other operations were performed	Do not perform any other operations	—
Unexpected control is detected.	on this unit while the AUTO SETUP	while the AUTO SETUP procedure is in
Please re-try.	procedure was in progress.	progress.
ERROR E-4	The IntelliBeam microphone is not	Make sure that the IntelliBeam	30
Please check MIC position. MIC	placed in front of this unit.	microphone is installed in front of this
should be set in front of YSP.		unit.
ERROR E-5	The IntelliBeam microphone is not	Make sure that the IntelliBeam	30
Please check MIC position. MIC	placed in the right distance from this	microphone is installed more than 1.8 m
should be set above 1.8m/6.0ft.	unit.	(6.0 ft) from the front of this unit and
		within 1 m (3.3 ft) from the center height
		of this unit.
ERROR E-6	The IntelliBeam microphone cannot	Make sure that the IntelliBeam	30
Volume level is lower than	collect the sound produced by this unit	microphone is firmly connected to this
expected. Please check MIC	because the sound output level is too low.	unit and placed in a proper location. If
position/connection and re-try.		the problem persists, contact the nearest
		authorized Yamaha service center for
		assistance.
ERROR E-7	An internal system error occurred.	Repeat the AUTO SETUP procedure.	—
Unexpected error happened.
Please re-try.

SETUP

English

35 En