Cutter Mode
Follow the instructions described in Roll Media with the exception of step 6: first route the media through the Cutter Module (see Figures 2.5 and 2.6) and then close the printhead assembly by moving the lever located on the upper printhead assembly to the CLOSED position.
Fanfold Media
To load fanfold media, place the fanfold media in the bottom or to the rear of the media compartment or Fanfold Supply Bin (105Se only) and thread it through the printhead as shown in Figures 2.7 and 2.8. Adjust the media guide using the thumb screw to keep the media from drifting left or right.
Fanfold media from outside the printer feeds through one of the two access slots, one at the bottom of the printer and one at the rear.
Figure 2.7 Fanfold Media Loading Diagrams (105Se)
Zebra |