Adjusting the Print Darkness
This procedure sets the darkness of the printing on the label. Use the lowest setting which provides the necessary print quality.
1.Press the MODE key. PAUSE and DARKEN lights turn ON.
2.Press UP or DOWN to adjust the current setting.
3.Press the MODE key three times. The MODE lights will flash ON and OFF to indicate that the settings have been saved in memory.
4.Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.
Adjusting the Media Rest Position
This procedure sets the
1.Press the MODE key twice briefly. PAUSE and POSITION lights turn ON.
2.Press UP or DOWN to adjust the current setting.
3.Press the MODE key twice briefly. The MODE lights will flash ON and OFF to indicate that the settings have been saved in memory.
4.Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.
Adjusting the Position of the Top of the Label
This procedure positions the printing on the label relative to the top edge of the label.
1.Press the MODE twice briefly then press and hold for about five sec- onds until the lights change. PAUSE and DARKEN and CALIBRATE lights turn ON.
2.Press UP or DOWN to adjust the current setting.
3.Press the MODE key twice briefly. The MODE lights will flash ON and OFF to indicate that the settings have been saved in memory.
4.Press PAUSE to exit PAUSE mode. PAUSE light turns OFF.
Zebra |