It is not necessary to turn printer power OFF prior to cleaning. If power is turned OFF, all label formats, images, and parameter settings stored in the printer’s formatting RAM will be lost. Permanent parameter settings stored in EEPROM will be retained. When power is turned back ON, it may be necessary to reload some items.
To clean the printhead and platen roller, open the media compartment door, refer to Figure 6.1, and perform the following steps:
1.Open the printhead by moving the printhead handle to the OPEN posi- tion.
2.Remove the media and ribbon (if present).
3.Moisten an applicator tip with Zebra Technologies Corporation- recommended solvent and wipe the print elements from end to end. (The print elements form the gray/black strip just behind the chrome strip. See Figure 6.1.) Allow a few seconds for the solvent to evapo- rate.
4.Rotate the platen roller and clean thoroughly with the solvent.
5.Brush/vacuum any accumulated paper lint and dust away from the roll- ers and the media and ribbon sensors.
6.Reload ribbon and/or media, close and latch the printhead, restore power (if necessary) and continue printing after the self test.
Media, Ribbon, and Label Available Sensors
These sensors should be cleaned on a regular basis to ensure proper operation of the printer. To locate the position of these sensors, refer to Figures
Cutter Module
Periodically, the Cutter Module should be cleaned to remove paper dust and label residue. Cleaning the Cutter Module ensures that labels will be cut properly and not jam in the cutter mechanism. Refer to
Zebra |