Zebra Technologies P330i, P330m user manual Take-up Spool Flange Supply Spool

Installation and Setup

Loading a Ribbon

b.Raise the Print Head Carriage by pressing the release latch to the left (toward the output hopper) and lifting as shown below to about a 45° angle. The Print Head Carriage will stay in that position, as shown at the right below.

Ribbon Take-up	Ribbon Supply
Spindle	Spindle

3.Locate the Ribbon Supply Spindle and the Ribbon Take-up Spindle (see above). Load ribbon onto the supply spindle (under the print head carriage) flange side in, and load the empty core (with tape attached) onto the take-up spindle. Make sure the ribbon comes off the top of the supply spindle and feeds to the top of the take-up spindle.

Take-up

Spool

Flange

Supply Spool

12 P330i & P330m Card Printer User’s Manual 980459-001 Rev C