Zebra Technologies P330i, P330m user manual Card Output Hopper

Installation and Setup

Card Output Hopper

Note • Do not try to eliminate the gap by pressing down on the card stack in the input hopper; this can cause misfeeds.

Card Output Hopper

The card output hopper is normally extended to receive the printed cards. The printer may be operated with the card output hopper in its closed position; in this case the cards will not be collected in the output hopper.

1.Pull the card output hopper out to place it in its functional position.

Note • The output hopper is a very snug fit to prevent it from moving during shipping or operation; firm force is required to change its position.

2.When not using the printer, slide the card output hopper back into its closed position to protect the printer from dust and protect the output hopper from damage.

3.The output hopper can be completely removed from the printer if necessary by inserting a thin, blunt object (such as a pencil) up through the hole in the bottom of the printer enclosure and pressing (up) to release the hopper while simultaneously pulling the hopper out. To re-install the output hopper, simply slide the output hopper in until it locks in place.

20 P330i & P330m Card Printer User’s Manual 980459-001 Rev C