Troubleshooting
Printer Diagnostics
FEED and PAUSE Self Test
Performing this self test temporarily resets the printer configuration to the factory default values. These values are active only until power is turned off unless you save them permanently in memory.
To perform a FEED and PAUSE self test, complete these steps:
1.Turn Off (O) the printer.
2.Press and hold FEED and PAUSE while turning the power On (I). Hold FEED and PAUSE until the DATA light turns off.
No labels print at the end of this test.
Communications Diagnostics Test
This test is controlled from the front panel display. See Setting Communications Mode
on page 52. Figure 54 shows a typical printout from this test. Turn off the power to exit this self test and return to normal operation.
Note • The communications test label prints
Figure 54 • Communications Diagnostics Test Label
Additional Printer Diagnostics
Additional diagnostic tests are available for this printer. See the Maintenance Manual for information about these additional tests.
R110Xi/R170Xi User Guide | 139 |